PRODUCT:

OdorCide® EZ 100X is designed for use in food service and food preparation facilities where organic odors and organic accumulation are a problem. When used as directed, this formulation will enzymatically clean hard surface areas, inanimate surfaces such as floors, shower stalls, stools, and drains. In addition, this formulation will deodorize those areas that generally are hard to keep fresh smelling such as garbage storage areas, empty garbage dumpsters and cans, rest rooms, and other areas that are prone to odor caused by microorganisms. Odor×Cide® EZ 100X is a special blend of enzymes, odor counteractants, and fragrances. Odor×Cide® EZ 100X will incrementally breakdown and remove organic buildup on the surface or in the drain.

APPLICATIONS:

Cleaner, mildewstat, and deodorizer of any waste system where decaying organics generate odor.

Meat Department, Dumpster, Produce Department, Rest Rooms, Empty Garbage Cans, Basements, Garbage Storage Areas, Bakery/Deli

MIXING:

To reduce 100X to 1X, add one part of 100X to 99 parts of water plus 2% non-ionic surfactant. It has been our experience that 5X, 10X and 15X are the most common strengths used.

1 part 100X plus 99 parts water plus 2% by weight surfactant = 1X
5 parts 100X plus 95 parts water plus 2% by weight surfactant = 5X
10 parts 100X plus 90 parts water plus 2% by weight surfactant = 10X
15 parts 100X plus 85 parts water plus 2% by weight surfactant = 15X

DIRECTIONS FOR USE (After Dilution):

Drain Odor Control

Pour 60ml directly into drain. The frequency of application depends upon organic accumulations in the drain line. If there is just a small amount of odor-causing organics in drain or P-trap one application may be sufficient. For heavy organic accumulations, in the drain line, repeat daily until drain runs free. NOTE: OdorCide® EZ 100X dilution should be used during the longest period of non-use, generally at the close of the day.

Surface Odor Control

Pre-clean surface to be treated and thoroughly saturate the area with OdorCide® EZ 100X dilution Let stand wet for 15 minutes and wipe off with a clean cloth or rinse with water. For very porous surfaces or hard to clean areas, repeat daily until the surfaces are clean and odor-free.CLEANING - Hold container 15 to 20 ml from surface to be treated. Spray area until it is covered with the solution. Allow product to penetrate and remain wet for 10 minutes. No scrubbing is necessary. Wipe off with a clean cloth, mop or sponge. The product will not leave grit or soap scum. For heavily soiled area, remove gross soil before treatment.

Mildewstat

To control mold and mildew on pre-cleaned, hard non-porous surfaces spray surface to be treated making sure to wet completely. Let air dry. Repeat application at weekly intervals or when mildew growth appears.